1. Place the reference slide and the donor block on microscope stage for position marking with an oil pen.
2. Place donor blocks and a recipient block on the block platform in UATM-272.
3. Extract the marked tissue from the donor block and deliver the extracted tissue into the corresponding holes of the pre-made recipient block (UB06) by using UATM-272.
4. Put the recipient block into embedding mold with cutting section faced down and incubate it in Oven at 60˚C for 30 minutes.
5. Take out the recipient block when completely transparent. ⇒ Embedding
6. Solidify the block in cold plate.
