1. Put the recipient block into the prop hole at bottom side.
2. Fit the 1mm guide on the prop.
3. Extract the marked tissue from the donor block by using Quick-Ray™ needle.
4. With fixing the prop by hand, insert the Quick-Ray™ needle into the guide hole, and put the extracted tissue into the recipient block hole by pushing the knob down.
5. Remove the guide and recipient block from the prop.
6.
Put the recipient block into embedding mold with cutting section faced down and incubate it in Oven at 60˚C for 30 minutes
7.
Take out the recipient block when completely transparent
⇒ Embedding
8.
Solidify the block in cold plate
9.
Cutting
* In case of using 2, 3 and 5mm recipient block, insert the extracted tissue directly into the recipient block without the guide by pushing the Quick-Ray™ knob down.
